News Center
nh3 Measurement for KEPCO

nh3 Measurement for KEPCO

The ammonia (NH3) gas is injected to remove the NOx and thus reduce the NOx concentration in the stack flue gas. With conventional NH3 analyzers that perform measurements indirectly, NH3 concentrations are obtained through a sampling system. Therefore, there are problems with the maintenance and running costs of the sampling system, and time delays in measurement.

[email protected]
News Detail
  • On-road measurement of NH3 emissions from gasoline

    2017-10-1NH 3 is a precursor of PM 2.5 which deteriorates urban air quality, affects human health and impacts the global radiation budget. Since vehicles are important sources of NH 3 in urban areas, we have satisfactorily studied the possibility of measuring NH 3 emissions from gasoline and SCR-equipped dieselCited by: 26

    Get Price
  • Measurement of NH3 Concentrations in Stack Flue Gas

    The ammonia (NH3) gas is injected to remove the NOx and thus reduce the NOx concentration in the stack flue gas. With conventional NH3 analyzers that perform measurements indirectly, NH3 concentrations are obtained through a sampling system. Therefore, there are problems with the maintenance and running costs of the sampling system, and time delays in measurement.

    Get Price
  • TDLAS‑based NH3 mole fraction measurement for

    2017-8-24line-of-sight measurement technique, a single TDLAS absorption path is sufficient for spatially integrated concen-tration measurements, whereas multiple beams can deliver an instant image of the concentration distribution, e.g., by tomography [26, 27]. The detection limit molecΔ which we discuss in this x paperCited by: 31

    Get Price
  • Measurement of NH3 Concentrations in

    Translate this pageThe ammonia (NH3) gas is injected to remove the NOx and thus reduce the NOx concentration in the stack flue gas. With conventional NH3 analyzers that perform measurements indirectly, NH3 concentrations are obtained through a sampling system. Therefore

    Get Price
  • Measurement of NO, NO2, NH3, and O2 at the SCR

    The NO X concentration is typically measured at the outlet of the SCR to calculate the denitrification efficiency. Ammonia is measured to ensure that NH3 slip is low. The GM32 in-situ gas analyzer measures NO and NO 2 (NO X) concentrations in the exhaust duct – directly, quickly, and without gas sampling and transport.The GM700 TDLS in-situ gas analyzer continuously monitors low NH 3

    Get Price
  • A miniDOAS instrument optimised for ammonia field

    Comparisons of miniDOAS measurements to those by NH3 acid trap devices showed good agreement. The miniDOAS can be flexibly used for a wide range of field trials, such as micrometeorological NH3

    Get Price
  • Reducing NH3 Slip in Selective Catalytic Reduction (SCR

    2019-7-16This excess NH3 is known as Ammonia Slip. There are two major ways to monitor NH 3 Slip – Differential Chemiluminescence of sample with NH 3 conversion, or Tunable Diode Laser (TDL) which provides a direct NH 3 measurement. Each method has its own merits, and drawbacks, which make specifying the correctAuthor: Jeremy Whorton

    Get Price
  • Transmission system reliability evaluation of KEPCO

    The KEPCO conducted a project on probabilistic reliability evaluation of practical power system which main purpose is to balance between the system reliability and the investment costs for

    Get Price
  • DS_AAM631 NH3 data sheet_图文_百度文

    Translate this pagewenku.baidu.com›百度文库›互联网2015-11-24A 9 AAM631 Aztec 600 ISE ammonia analyzer Specification Measurement Units — NH3 — NH3-N — NH4 Range — 0.050 to 1000 ppm NH3 Measurement principle Gas-sensing ammonia probe Measurement mode Continuous Measurement performance

    Get Price
  • The Effectiveness of Pretreatment Methods on COD

    2015-8-27measurements were carried out following laboratory procedures according to the Standard Methods [19]. Dissolved organic carbon (DOC) analyses were performed using the Fusion Total Organic Carbon Analyzer (TELEDYNE TEKMAR). Ammonnia (NH. 3. N), was measured using an automatic flow injection

edge-iconRelated News
toTop
Click avatar to contact us
Chat Online